Co sa tyka "jemneho doladenia HW100" alias fine tuning som sa docital, ze je lepsie mat o troska viac nastaveny regulator cca.95bar a jemnejsie nastavenie udernika...zevraj sa tym setri aj zivotnost ventilu - kladivo neudiera takou silou...
Moze toto potvrdit alebo vyvratit aj Bench Rest?
Tu je zdroj:
http://weihrauchowners.freeforums.org/h ... b77c6ffa3etu je len "vycuc"
mdk01 is right - more than likely too low reg pressure, so you have to compensate with a higher hammer tension. A lot of people are adjusting the reg pressure to a slightly higher pressure e.g 95bar and this allows for the hammer to be slackened - reducing bounce. Really you need a reg tester for this - I offer mine to "borrow" should you require it. (free of charge)
However - this is only achievable if you have removed the "factory restriction" on the HW100. I and a couple of others on here have had some "tuning kits" made up that with a little bit of work converts the HW100 to its fully adjustable version - these adjustments are to keep the weapon within UK legal limits. Ideal for tuning the hammer bounce.
Disclaimer:
Replacing the factory restriction is COMPLETELY LEGAL.
As well all know 12fpe is the legal maximum for a UK airgin without an FAC ticket - penalties are severe and its your responsibility to keep it below 12fpe NO ONE ELSES.
Este zaujimave poctenicko:
http://weihrauchowners.freeforums.org/b ... ot%20count